Better Results But Still Hurting.

 Location today is Windsor, Ontario.

Click on the pictures to enlarge.

After the PTA did its usual devil may care job yesterday instead of following the Numerical Directions on the Spreadsheet, I wasn’t about to have a repeat today. We did everything possible to prevent that, including going one step further. I found that by taping a Pencil to the Torch, I could run a weld test without the Arc to fine tune the Positioner Speed. The end result was a weld that looked the way it was supposed to.

Since we were using the Number 83 Hard-Surfacing Powder it caused another problem. It tends to cause the Orifice to constantly plug. Stopping the weld, to clean things up on the Torch was needed at least Ten Times, but that was a big improvement from yesterday.

The only other problem was my Leg started to give out on me at the end of the shift. Since we are seeing our Family Doctor tomorrow, maybe he can shed some light on the subject.

Thanks for following along and feel free to leave a comment, unless it personally attacks someone for their opinion, or is Spam.

Be Safe and Enjoy!

It’s about time.

Krackers

You Might Be a Redneck If

You watch cartoons long after your kids get bored.